Billy Goat KD VACUUM KD 410 Manuale Utente Scaricare il pdf (Pagina 5)

Part No. 890564 Form No. F022502A

Page 5 of 8

VACUUM NOZZLE HEIGHT ADJUSTMENT: is

raised and lowered by pulling slightly upward on handle

and pulling height adjust control (item 23) out on left side of

handle. (Note: Top notch is intended for use with hose kit

to cut off intake air.)

FOR MAXIMUM PICKUP: Adjust nozzle close to

debris, but without blocking airflow into the nozzle.

NOTE

: Never

bury nozzle into debris.

CLEARING A CLOGGED NOZZLE

& EXHAUST: Turn engine off and wait for impeller to

stop completely and disconnect spark plug wire.

Wearing durable gloves, remove clog. Danger, the

clog may contain sharp materials. Reconnect spark

plug wire.

ENGINE: See engine manufacturer’s instructions

for type and amount of oil and gasoline used.

Engine must be level when checking and filling oil and

gasoline.

FUEL VALVE: Move fuel valve to "ON" position (when

provided on engine).

PRIMER: Push primer per engine instructions.

IF YOUR UNIT FAILS TO START:

See Troubleshooting on page 8.

INTENDED USE: This machine is designed for vacuuming

leaves, grass clippings and other types of organic litter.

Debris mixed with cans, bottles and small amounts of sand

can be vacuumed; however, it is not this machine's primary

purpose. Vacuuming cans, bottles and sand will affect the

longevity of your machine.

PUT OIL IN ENGINE BEFORE STARTING.

Inspect machine work area and machine before operat-

ing. Make sure that all operators of this equipment are

trained in general machine use and safety.

Do not operate if excessive vibration occurs. If excessive

vibration occurs, shut engine off immediately and check for

damaged or worn impeller, loose impeller bolt, loose impeller

key, loose engine or lodged foreign objects. Note: See parts

list for proper impeller bolt torque specifications. (See trouble

shooting section on page 8).

1414

Operation

STARTING

14.114.1

14.1

VACUUMING OPERATION

14.214.2

14.2

Like all mechanical tools, reasonable care must

be used when operating machine.

Using two people to lift machine is recommended. Lift holding the

handle and front of nozzle. Secure in place during transport.

Never store engine indoors or in enclosed poorly venti-

lated areas with fuel in tank, where fuel fumes may reach an

open flame, spark or pilot light, as on a furnace, water heater,

clothes dryer or other gas appliance.

If engine is to be unused for 30 days or more, prepare as

follows:

Be sure engine is cool. Do not smoke. Remove all

gasoline from carburetor and fuel tank to prevent gum deposits

from forming on these parts and causing possible malfunction

of engine. Drain fuel outdoors, into an approved container,

away from open flame. Run engine until fuel tank is empty

and engine runs out of gasoline.

NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable

alternative in minimizing the formation of fuel gum deposits

during storage. Add stabilizer to gasoline in fuel tank or

storage container. Always follow mix ratio found on stabilizer

container. Run engine at least 10 min. after adding stabilizer to

allow it to reach the carburetor.

Do not store with debris in bag.

14.514.5

14.5

HANDLING & TRANSPORTING:

STORAGE

Note: Frequently empty debris to prevent bag overloading with

more weight than you can lift.

An optional bag and dust cover is available for use where debris will be

vacuumed in dusty conditions (see Optional Accessories shown on

page 1).

DO NOT place bag on or near hot surface, such as engine. Your

new bag requires a break-in period to condition the pores of the

material against premature blockage. The entire bag surface serves

as a filter, and must be able to breath to have good vacuum

performance.

Be sure engine has come to a complete stop before removing

or emptying bag.

This vacuum is designed for picking up trash, organic

material and other similar debris

(see Safety Warnings page 2-3).

However, many vacuums are used where dust is mixed with

trash. Your unit can intermittently vacuum in dusty areas. Dust

is the greatest cause of lost vacuum performance. However,

following these rules will help maintain your machine's ability to

vacuum in dusty conditions:

•The debris bag must be cleaned more frequently. A vacuum

with a clean, pillow soft bag will have good pickup perfor-

mance. One with a dirty, tight bag will have poor pickup

performance. If dirty, empty debris and vigorously shake bag

free of dust.

•Machine or pressure-wash debris bag if normal cleaning does

not fully clean bag. Bag should be thoroughly dry before use.

Having one or more spare debris bags is a good way to reduce down time

while dirty bags are being cleaned.

•DO NOT leave debris in bag while in storage.

Debris bags are normal replaceable wear items.

DEBRIS BAG

Vacuumed leaves, grass and other organic material from your own

yard can be emptied into a pile or composter to provide enriched

soil for later use as fertilizer in gardens and flower beds (see fig. 3).

Note: Allow green chips to dry before spreading around living

plants.

COMPOST

1010

14.414.4

14.4

1 2 3 4 5 6 7 8 9

Commenti su questo manuale

Nessun commento

Billy Goat KD VACUUM KD 410 Manuale Utente Pagina 5

Commenti su questo manuale

Prodotti e manuali riguardandi Aspirapolvere Billy Goat KD VACUUM KD 410